Asynchronous Terminals and Printer Processes Configuration and Management Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Configuration Quick Start
- 2 Overview of the ATP6100 Subsystem
- 3 Configuring the ATP6100 Subsystem
- 4 Printer Profiles and Default Modifiers
- 5 Terminal Profiles and Default Modifiers
- 6 ManagingATP6100Usingthe SubsystemControlFacility(SCF)
- 7 PTrace Facility for ATP6100
- A ATP6100 Subsystem Error Messages
- B SCF Command Summary for ATP6100
- ABORT LINE Command
- ABORT SU Command
- ACTIVATE SU Command
- ALTER LINE Command
- ALTER SU Command
- INFO LINE Command
- INFO SU Command
- LOAD LINE Command
- START LINE Command
- START SU Command
- STATS LINE Command
- STATS SU Command
- STATUS LINE Command
- STATUS SU Command
- STOP LINE Command
- STOP SU Command
- SUSPEND SU Command
- SWITCH PROC Command
- TRACE LINE Command
- VERSION PROC Command
- C Moving to G-Series or H-Series RVUs
- Glossary
- Index
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
1-1
1 Configuration Quick Start
This section is a configuration quick start for the Asynchronous Terminals and Printer
Processes (ATP6100) subsystem. This procedure explains how to set up the initial
ATP6100 processes on an Integrity NonStop NS-series or NonStop S-series server.
For an overview of the ATP6100 subsystem, refer to Section 2, Overview of the
ATP6100 Subsystem
To help you complete the configuration tasks quickly, this section recommends you
accept the default values provided by the ATP6100 subsystem. If you want to change
your ATP6100 configuration, or if you want to complete the initial configuration without
using the default configuration values, refer to the appropriate sections of this manual.
Task Summary
1. Log On to the NonStop Server and Obtain SWAN/SWAN 2 Information on
page 1-2
2. Add an ATP6100 Profile on page 1-4
3. Add an ATP6100 Device on page 1-5
4. Start the ATP6100 Line on page 1-5
Assumptions
At the beginning of the procedure, the NonStop NS-series or NonStop S-series server
is in the following state:
•
The default software configuration is as shipped by manufacturing.
•
The initial TSM or OSM configuration is complete. Note that TSM is not supported
on Integrity NonStop NS-series servers.
•
The ServerNet LAN Systems Access (SLSA) subsystem has been defined and
started. Also, a LAN adapter (for example, a Gigabit Ethernet 4-port ServerNet
adapter (G4SA) has been installed and started). Note that the G4SA can only be
installed in an I/O Adapter Module (IOAM) enclosure. For more information, see
the Gigabit Ethernet 4-Port Adapter Installation and Support Guide.
•
A NonStop TCP/IP process has been defined and started. Note that Parallel
Library TCP/IP is not supported on Integrity NonStop NS-series servers.
•
The WAN manager process ($ZZWAN) has been defined and started.
•
The WAN processes CONMGR process is defined and started. The WANBOOT,
TFTP, and SNMP are automatically started.
•
The SWAN/SWAN 2 concentrator has been installed, defined and started and has
an available WAN line.