Asynchronous Terminals and Printer Processes Configuration and Management Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Configuration Quick Start
- 2 Overview of the ATP6100 Subsystem
- 3 Configuring the ATP6100 Subsystem
- 4 Printer Profiles and Default Modifiers
- 5 Terminal Profiles and Default Modifiers
- 6 ManagingATP6100Usingthe SubsystemControlFacility(SCF)
- 7 PTrace Facility for ATP6100
- A ATP6100 Subsystem Error Messages
- B SCF Command Summary for ATP6100
- ABORT LINE Command
- ABORT SU Command
- ACTIVATE SU Command
- ALTER LINE Command
- ALTER SU Command
- INFO LINE Command
- INFO SU Command
- LOAD LINE Command
- START LINE Command
- START SU Command
- STATS LINE Command
- STATS SU Command
- STATUS LINE Command
- STATUS SU Command
- STOP LINE Command
- STOP SU Command
- SUSPEND SU Command
- SWITCH PROC Command
- TRACE LINE Command
- VERSION PROC Command
- C Moving to G-Series or H-Series RVUs
- Glossary
- Index
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
4-1
4
Printer Profiles and Default
Modifiers
This section gives an overview of ATP6100 printer profiles, lists the contents of each
profile, and describes the default modifiers contained in each profile.
Printer Profiles
Printer profiles contain modifiers and default modifier values for different ATP6100 line-
handler processes. You create a profile from an object file provided by HP or from a
previously created profile. This subsection lists the printer object files provided by HP
for ATP6100 and the contents of each HP-provided profile.
Table 4-1 defines the printer object files that are provided by HP for ATP6100. These
object files are installed in $SYSTEM.SYSnn.
For more information about creating profiles, refer to the WAN Subsystem
Configuration and Management Manual.
Note. You cannot list object files or read their contents. Profiles are also object files, not edit
files. Therefore, you cannot list profiles or read the contents of a profile. HP recommends that
you create profiles by using a command (OBEY) file or otherwise keep a written note of the
contents and locations of the profiles you create.
Note. Use only the profile which supports the device you are installing.
Table 4-1. Object Files for ATP6100 Printer Profiles
Object File Name Profile Name Supported Device
$SYSTEM.SYSnn.PATP5512 PATP5512 5512 printer
$SYSTEM.SYSnn.PATP5515 PATP5515 5515 printer
$SYSTEM.SYSnn.PATP5516 PATP5516 5516 printer
$SYSTEM.SYSnn.PATP5520 PATP5520 5520 printer
$SYSTEM.SYSnn.PATP5530 PATP5530 5530 printer
$SYSTEM.SYSnn.PATP5540 PATP5540 5540 printer
$SYSTEM.SYSnn.PATP5573 PATP5573 5573 printer
$SYSTEM.SYSnn.PATP5577 PATP5577 5577 printer
$SYSTEM.SYSnn.PATPPRT PATPPRT Non-HP printer