Asynchronous Terminals and Printer Processes Configuration and Management Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Configuration Quick Start
- 2 Overview of the ATP6100 Subsystem
- 3 Configuring the ATP6100 Subsystem
- 4 Printer Profiles and Default Modifiers
- 5 Terminal Profiles and Default Modifiers
- 6 ManagingATP6100Usingthe SubsystemControlFacility(SCF)
- 7 PTrace Facility for ATP6100
- A ATP6100 Subsystem Error Messages
- B SCF Command Summary for ATP6100
- ABORT LINE Command
- ABORT SU Command
- ACTIVATE SU Command
- ALTER LINE Command
- ALTER SU Command
- INFO LINE Command
- INFO SU Command
- LOAD LINE Command
- START LINE Command
- START SU Command
- STATS LINE Command
- STATS SU Command
- STATUS LINE Command
- STATUS SU Command
- STOP LINE Command
- STOP SU Command
- SUSPEND SU Command
- SWITCH PROC Command
- TRACE LINE Command
- VERSION PROC Command
- C Moving to G-Series or H-Series RVUs
- Glossary
- Index
Printer Profiles and Default Modifiers
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
4-13
Printer Modifiers
CLBTIMEOUT n
This modifier specifies the CLB timeout. The default of 800 (8 seconds) allows optimal
resource use. A value larger than the default may result in excessive timeouts.
CLBWINDOW n
This modifier specifies the number of CLB read buffers allocated. The default of 1
allows optimal resource use. A value larger than the default may result in excessive
buffers.
CMGLDEV
This modifier specifies the CONMgr logical device id and should not be altered.
CTSFLOW
This modifier specifies that the CTS flow-control handshake is in effect for data
transferred between a concentrator and a serial printer. When CTS (pin 5) is set
(HIGH) at the concentrator interface, the concentrator transmits data; when CTS is
reset (LOW), the concentrator stops sending data. Typically, DTR (pin 20) at the serial
printer interface is connected to CTS (pin 5) at the concentrator interface.
The CTS flow-control handshake requires a serial interface (see the EIA modifier).
Application: SWAN/SWAN 2 concentrator
Default: n = 800 (8 sec)
Units: .01 seconds
Range: 350 through 32767
Application: SWAN/SWAN 2 concentrator
Default: n = 1
Range: 1 through 8
Application: SWAN/SWAN 2 concentrator
Default: 0
Application: Serial printers