Asynchronous Terminals and Printer Processes Configuration and Management Manual

Table Of Contents
Printer Profiles and Default Modifiers
Asynchronous Terminals and Printer Processes Configuration and Management Manual424280-003
4-16
Printer Modifiers
ETXFLOWCHAR n
This modifier specifies the ETX character used by the ETX(ENQ)/ACK flow-control
handshake.
EVEN
This modifier specifies even parity for data sent from the concentrator to the serial
printer.
FULL
This modifier specifies that full-duplex (two-way simultaneous) transmission is in effect
between the concentrator and the serial printer.
HALF
This modifier specifies that half-duplex (two-way, not simultaneous) transmission is in
effect between the concentrator and the serial printer.
HARD
This modifier specifies that the concentrator is directly connected to the serial printer
through a set of wires (a cable).
Application: Serial printers
Default: n = 3
Units: ASCII characters
Range: All characters in ASCII character set
See also: ETXFLOW
Application: Serial printers
See also: CHECK, NOCHECK, NONE, ODD
Application: Serial printers
See also: HALF
Application: Serial printers
See also: FULL
Application: Serial printers
See also: MODEM