Asynchronous Terminals and Printer Processes Configuration and Management Manual

Table Of Contents

Terminal Profiles and Default Modifiers

Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003

5-12

Terminal Modifiers

This subsection describes all modifiers contained in the terminal profiles and all other

modifiers that can be used with the ATP6100 terminal profiles. For detailed information

on using the Subsystem Control Facility (SCF) to alter the default values for the

duration of the current session, refer to Section 6, Managing ATP6100 Using the

Subsystem Control Facility (SCF). For detailed information on permanently altering the

modifier default values contained in the terminal profiles or creating a new profile, refer

to the WAN Subsystem Configuration and Management Manual.

ASYNC

This modifier specifies the operational class of the download module as asynchronous.

If an appropriate module is not found in the download file, the operation terminates.

When the ASYNC modifier is included in the PROFILE file, the ConMgr process

checks to make sure that the operational modifier specified in the microcode file

matches the line configuration. If they do not match, the microcode download does not

occur; however, you will not receive an SCF error. If the operational modifier does not

match the line configuration, you will receive a system error stating that the microcode

was not downloaded after the attempted download to the CLIP.

AUTODCONNECT

This modifier supports European CCITT-standard, full-duplex modems. It causes the

system to monitor the Carrier Detect (CD) signal in addition to its normal monitoring of

the Data Set Ready (DSR) signal during read and write operations.

If an error occurs during processing of a CONTROL 11 (modem connect operation),

the communications line is disconnected.

AUTOLOAD

This modifier specifies that the CONMGR automatically downloads the line interface

unit (LIU) if the LIU responds to a status probe with an error condition.

Application: All terminals

Application: SWAN/SWAN 2 concentrator