Asynchronous Terminals and Printer Processes Configuration and Management Manual

Table Of Contents

Terminal Profiles and Default Modifiers

Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003

5-20

Terminal Modifiers

DUAL212

This modifier specifies that the concentrator use the baud rate (1200 or 300) indicated

by the Bell 212-type modem. When Secondary Receive Line Detect (SRLD) is set

(HIGH) at the concentrator interface (pin 12), the concentrator interface operates at

1200 baud; when SRLD is reset (LOW), it operates at 300 baud.

ECHO

This modifier causes incoming characters to be echoed back to the terminal if it’s in

conversational, full-duplex mode.

ECHOBREAK

Once the BREAK key is pressed at a terminal, it continues to be sent to the system

until disabled. This modifier causes a break to be returned to the terminal to disable a

continuous break condition.

EIA

This modifier specifies that the concentrator interface operate as an RS-232C

interface.

ETB n

This modifier specifies the character to be used as the end-of-transmission-block

character. If you specify this modifier, you must also specify ETX n.

Application: All terminals