Asynchronous Terminals and Printer Processes Configuration and Management Manual

Terminal Profiles and Default Modifiers
Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003
5-21
Terminal Modifiers
ETX n
This modifier (end of text) specifies the number of characters in the checksum
following a line-terminating ETX or ETB character; the checksum is returned to the
application.
ETXCHAR n
This modifier specifies the character to be used as the end-of-text (ETX) character. If
you specify this modifier, you must also specify ETX n.
EVEN
This modifier specifies even parity for data sent from the concentrator to the terminal.
FULL
This modifier specifies that full-duplex (two-way simultaneous) transmission is in effect
between the concentrator and the terminal.
HALF
This modifier specifies that half-duplex (two-way, not simultaneous) transmission is in
effect between the concentrator and the terminal.
Application: All terminals
Default: None
Units: Bytes
Range: 1 or 2
See also: ETB, ETXCHAR
Application: All terminals
Default: n = 3
Units: ASCII characters
Range: All characters in ASCII character set
See also: ETX n, ETB
Application: All terminals
See also: CHECK, NOCHECK, NONE, ODD
Application: All terminals
See also: HALF
Application: All terminals
See also: FULL