Asynchronous Terminals and Printer Processes Configuration and Management Manual

Table Of Contents

Terminal Profiles and Default Modifiers

Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003

5-23

Terminal Modifiers

INTCHAR x n

This modifier allows specification of up to four interrupt character for terminals at the

line or subdevice level. The default values are

INTERFACELEVEL

This modifier specifies the clip interface level which is supplied to the CONMgr while

downloading the clip.

LFSYS

This modifier specifies that the concentrator send an LF character (10) in response to a

CR character sent by the terminal.

LFTERM

This modifier specifies that the terminal is to supply an LF character (10) following a

CR character.

Application: All terminals

Range: x = 1 through 4

n = the range of the ASCII character set

Default: See table below