Asynchronous Terminals and Printer Processes Configuration and Management Manual

Table Of Contents

Terminal Profiles and Default Modifiers

Asynchronous Terminals and Printer Processes Configuration and Management Manual—424280-003

5-29

Terminal Modifiers

PROFILEID

This modifier keyword specifies the profile version. This is used to avoid

IOPOBJECT and Profile Version mismatch.

PROGRAM file_name

This modifier specifies the name of the line interface unit (LIU) download module for a

terminal.

For terminals, this modifier specifies that a half-duplex, Bell 202-type modem with

reverse channel is connected to an LIU-1. These modems require that Request To

Send (RTS) be dropped when switching from transmit to receive.

RC checks the XFERSIZE value before it transmits data.

RECSIZE n

This modifier specifies the record size, in bytes, for the terminal. The record size is the

maximum number of characters transferred in a line, after which the line is terminated

(for example, with a CR and an LF). Newer graphics and dot-matrix printers may

require a value greater than the default.

Application: All terminals and printers

Default: Depends on IBM

Range: Default value cannot be altered

Application: SWAN concentrator

Default: file_name = C1094P00

Application: SWAN 2 concentrator

Default: file_name = C1094Q00

Note. By default, profiles contain the value C1094P00 (for SWAN). To add an ATP line on a

SWAN 2 concentrator C1094Q00 has to be specified explicitly.

Application: All terminals