Asynchronous Terminals and Printer Processes Programming Manual

CONTROL, CONTROLBUF, AND SETMODE FOR PRINTERS
SETMODE Operations
For subtype 6:
parameter = 0 disable automatic perforation skip
1 enable automatic perforation skip (default)
parameter-2 is not used.
6 = set system spacing control and transparency |
parameter-1 . 15 = 0 no space
1 single space (default)
parameter-2 = 0 no transparency (default) |
1 transparency |
|
You can issue the following parameter combinations for the |
SETMODE 6 operation: |
|
0, 0 appends <CR> |
1, 0 appends <CR><LF> or equivalent |
0, 1 does not append form control |
1, 1 appends <CR><LF> or equivalent |
|
|
NOTE |
|
The set transparency parameter is available only for the |
5512, 5515/5516, 554x, and 5573 printers in the ATP6100 |
environment. If you issue SETMODE 6, 0, 0, 5515/5516 |
printers overwrite the last two writes. However, if you |
issue SETMODE 6, 0, 1, 5512 and 5573 printers poll for |
primary status, send the byte count, and then print text. |
22 = set baud rate. For subtypes 3, 4, 6, and 32:
parameter-1 = 0 baud rate 50
1 baud rate 75
2 baud rate 110
3 baud rate 134.5
4 baud rate 150
5 baud rate 300
6 baud rate 600
7 baud rate 1200
8 baud rate 1800
9 baud rate 2000
10 baud rate 2400
11 baud rate 3600
12 baud rate 4800
13 baud rate 7200
14 baud rate 9600
15 baud rate 19200
16 baud rate 200
Novemeber 1987 C-3