Atalla Boxcar Reference Guide (G06.24+)

Atalla Boxcar Reference Guide—526564-005

Table 1. Boxcar Parameters (page 1 of 2)

Command Default Description

BOXCAR-BACKUPCPU Sets the number of the CPU that runs

the Boxcar backup process. If not

specified, the Boxcar process does not

run as a persistent process pair.

BOXCAR-CRLF-REQUIRED Used to specify if a Carriage Return

and Line Feed (CRLF) characters

should be appended to each NSP

response.

YES = append CRLF

NO = do not append CRLF

If not specified, Boxcar logs an error

and terminates.

BOXCAR-DEBUG-FILE This is the name of the debug file. Only

use this parameter for

troubleshooting, it significantly

degrades performance.

BOXCAR-DEVICE-NAME Specifies the IP address of the NSP. If

not specified, Boxcar logs an error and

terminates.

BOXCAR-DEVICE-TYPE 15-3 Specifies the device and subtype.The

device and subtype must be separated

by a dash character.

BOXCAR-ETHERNET-PORT 7000 Specifies the port number for the NSP.

BOXCAR-LOGFILE Establishes the name of the Boxcar log

file or log process name. If not

specified, Boxcar logs an error and

terminates.

BOXCAR-LOGMSGWRITEINTERVAL 0 Controls how often messages certain

types of messages are logged.

BOXCAR-MAX-FLATSEG-SIZE 133MB This parameter can be used to specify

a smaller swap space, which is used by

Boxcar to store commands and

responses.

BOXCAR-MAXSOCKET-OPENS 14 Specifies the maximum number of

socket opens that can be performed on

an NSP. If Boxcar is unable to open any

sockets, it logs an error and terminates.

BOXCAR-RECV-DEPTH 4047 Used to change the Receive Depth

value, $RECEIVE, from the default

value of 4047. The maximum allowed

value is 4047.