ATM Adapter Installation and Support Guide

ATM Adapter Installation and Support Guide—420013-002
2-1
2 Installing an ATM3SA Adapter
An ATM3SA adapter can be installed without taking down the system.
This procedure describes how to configure and install an ATM ServerNet adapter
(ATM3SA) in a NonStop S-series server. For new systems, HP has installed,
configured, and tested the adapter. See Section 3, Replacing an ATM3SA Adapter for
detailed instructions about removing and replacing the adapter. To move an adapter to
a different location, see Section 2, Installing an ATM3SA Adapter and Section 3,
Replacing an ATM3SA Adapter. The following topics are covered in this section:
•
Prepare to Install the ATM3SA Adapter
•
Install the ATM3SA Adapter
Table 2-1 shows the part numbers for the ATM3SA adapter and filler panel.
Prepare to Install the ATM3SA Adapter
This section describes those tasks you should perform before installing or configuring
the ATM3SA adapter. Table Table 2-2 summarizes the steps involved.
Table 2-1. Part Numbers for ATM3SA Adapter
Description Part Number
3860 ATM ServerNet adapter (ATM3SA) 108502
Filler panel 109023
Table 2-2. Preparation Checklist
Step Description Comments
1.
Plan the Local Area Network (LAN)
2.
Complete the Configuration Form
A sample form is
provided. See Figure 2-1
on page 2-3. See also
Appendix A, ATM3SA
Adapter Configuration
Form.
4.
Gather the Proper Tools
5.
Review Standard Operating Practices