ATM Adapter Installation and Support Guide

Installing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
2-2
Plan the Local Area Network (LAN)
Plan the Local Area Network (LAN)
For information about planning your LAN and about network addresses, review the
LAN Configuration and Management Manual, and refer, if necessary, to the following
manuals:
•
NonStop S-Series Planning and Configuration Guide
•
TCP/IP Configuration and Management Manual
•
ATM Adapter Configuration and Management Manual
Complete the Configuration Form
When you add an adapter to a NonStop S-series system, you specify:
•
A name you use to identify the adapter; for example, AM3 for an ATM3SA adapter
in slot 53 of the first system enclosure.
•
The location of the adapter within the system cabinet (group, module, and slot).
•
The processors that have access to the SACs on the adapter.
Before you begin the hardware installation, you should complete an ATM3SA
configuration form. Obtain the form from Appendix A, ATM3SA Adapter Configuration
Form and complete the following steps:
•
Enter the name of the system in the System Name field.
•
Enter the group number for this enclosure in the Group Number field.
•
Enter the slot number of this ATM3SA adapter in the Slot Number field. ATM3SA
adapters can be installed in slots 51, 52, 53, and 54 of an I/O enclosure or a
processor enclosure.
•
Enter the following:
•
ATM address
•
adapter name
•
LINE name
•
SAC access list
•
When you have completed this form, enter today’s date in the date field.
Figure 2-1 shows an example of a completed ATM ServerNet Adapter (ATM3SA)
Configuration Form.
Note. For possible slot locations for the ATM3SA adapter, see ATM3SA Adapter Slot
Locations on page 2-4.