ATM Adapter Installation and Support Guide

Installing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
2-9
Unpack and Install the ATM3SA Adapter
Install the ATM3SA Adapter
1. With the ejector on and the ATM3SA adapter in the full-open position (Figure 2-6),
grasp the ATM3SA adapter by the ejector with one hand and support the bottom
edge of the ATM3SA adapter with the other hand (Figure 2-7 on page 2-11). Hold
the ATM3SA adapter so that its ejector is at the top, as shown in Figure 2-6, and
insert the ATM3SA adapter into the upper part of the carrier.
Figure 2-5. Grounding Clip
Grounding
Clip
VST008.vsd
Processor Multifunction (PMF) or
I/O Multifunction (IOMF) CRU
To Grounding Wriststrap