ATM Adapter Installation and Support Guide

Installing an ATM3SA Adapter

ATM Adapter Installation and Support Guide—420013-002

2-12

Check the Installation of the ATM3SA Adapter

To check the installation of an ATM3SA adapter:

1. Make sure that the power-on LED (green light) is on.

Figure 2-8

shows the location of the power-on LED and fault LED.

Figure 2-8. ATM3SA Adapter Hardware Connection

Note. When the adapter is inserted, the fault LED (yellow light) remains on until the

service processor has completed its start-up configuration; the fault LED also turns on

when a POST failure is detected.

Transmit

Receive

Status

LEDs

Ejector

VST010.VSD

Vendor ATM Switch

ServerNet ATM Adapter