ATM Adapter Installation and Support Guide

Installing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
2-13
Use SCF to Add the ATM3SA Adapter
2. If the power-on LED does not come on, do one or both of the following:
•
Reseat the ATM3SA adapter.
•
Check the ATM3SA adapter and backplane connector for damaged pins.
Note Possible Error Conditions
•
If the power-on LED does not come on after you reseat the ATM3SA adapter, you
must replace the ATM3SA adapter.
•
If the ATM3SA adapter or backplane connector have damaged pins, both the
ATM3SA adapter and backplane (or enclosure) must be replaced. For backplane
replacement instructions, refer to the NonStop S-Series Service Provider
Supplement.
Use SCF to Add the ATM3SA Adapter
Using the ATM3SA completed configuration form as a guide, use SCF to add and
configure the ATM3SA adapter.
1. Use the SCF ADD ADAPTER command to add the adapter to the ATM subsystem.
2. Use the SCF START ADAPTER command to start the adapter.
3. Use the SCF STATUS ADAPTER command to verify that the ATM3SA adapter
object is in the STARTED state:
4. Use the SCF ALTER LINE command to configure the ATM address.
5. Use the SCF START LINE command to start the LINE object.
6. Use the SCF START ATMSAP command to start the ATMSAP object.
->ADD ADDAPTER $ZZATM.$AM2, LOCATION (1,1,53), ACCESSLEST (0,1), dfc 10, dft 10
->START ADAPTER $AM2
->STATUS ADAPTER $AM2
->ALTER LINE $AM2, ATMADDR (isonsap:%h4700dd01272b4a00000000000000000000000100)
->START LINE $AM2
Note. The LINE and ATMSAP objects are created automatically by the ASM.
->START ATMSAP $AM2.#IP