ATM Adapter Installation and Support Guide

Replacing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
3-5
Identify Communications Lines Using the ATM3SA
Adapter
•
The Internet Protocol (IP) address is displayed in the IPADDRESS column
In this example, which is partial output, the ATM line named $AM2 in associated
with the subnet named #SN2 on the TCP/IP PROCESS NAMED $ZTC01 and has
the IP address 172.16.192.20.
2. Identify the names of Expand-over-IP and Expand-over-ATM lines configured on
the system.
a. To display the single Expand-over-IP and Expand-over-ATM lines, use the
following SCF LISTDEV command :
LISTDEV TYPE 63,0
Example 3-2 shows the output of this command.
In this example, one Expand-over-ATM line (named $ATMLH) and one
Expand-over-IP line (named $IPCORE) are configured on the system.
b. To display the Expand-over-IP and Expand-over-ATM lines that are part of a
multiline path, use the following SCF LISTDEV command:
LISTDEV TYPE 63,2
Example 3-3 shows the output of this command.
In this example, two Expand-over-ATM line (named $ATMLH1 and $ATMLH2)
are configured as part of a multiline path.
3. Determine if any of the Expand-over-IP or Expand-over-ATM lines configured on
the system use the ATM3SA adapter.
Use the SCF INFO LINE command with the DETAIL option for each Expand-over-
IP and Expand-over-ATM line:
INFO LINE $line-name, DETAIL
Note. You can find for ATM subnets by looking in the TYPE column. ATM subnets are
displayed as type ATM.
Example 3-2. SCF LISTDEV Command
->LISTDEV TYPE 63,0
LDev Name PPID BPID Type Rsize Pri Program
109 $ATMLH 3,9 2,7 (63,0) 3 199 \COWBOY.$DATA00.T9057ADJ.LHOBJ
159 $IPCORE 0,16 1,15 (63,0) 3 199 \COWBOY.$DATA00.T9057ADJ.LHOBJ
Example 3-3. SCF LISTDEV Command
->LISTDEV TYPE 63,2
LDev Name PPID BPID Type Rsize Pri Program
56 $ATMLH1 2,16 3,16 (63,2) 3 199 \COWBOY.$DATA00.T9057ADJ.LHOBJ
84 $ATMLH2 2,16 3,16 (63,2) 3 199 \COWBOY.$DATA00.T9057ADJ.LHOBJ