ATM Adapter Installation and Support Guide

Replacing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
3-9
Determine the Physical Location of the ATM3SA
Adapter
5. Stop the TCP/IP subnets associated with the Asynchronous Transfer Mode (ATM)
line on the ATM ServerNet adapter (ATM3SA).
Use the SCF STOP SUBNET command:
STOP SUBNET $tcpip-process-name.#subnet-name
6. Verify that the TCP/IP subnets are in the STOPPED state.
Use the SCF STATUS SUBNET command:
STATUS SUBNET $tcpip-process-name.#subnet-name
Example 3-10 shows the output of this command.
Note that the subnet is in the STOPPED state.
Determine the Physical Location of the ATM3SA Adapter
To determine the physical location of an ATM3SA adapter:
1. Use the SCF INFO ADAPTER command:
INFO ADAPTER $adapter-name
2. Check the output of the command for the group, module, and slot location. Record
this information in your log book.
Example 3-11 shows the output of this command.
Caution. Make sure that the TACL session from which you are issuing SCF commands is not
running on the one of the subnets that you are about to stop.
Example 3-10. SCF STATUS SUBNET Command
->STATUS SUBNET $ZTC01.#SN2
TCPIP Status SUBNET \COWBOY.$ZTC01.#SN2
Name Status
#SN2 STOPPED