ATM Adapter Installation and Support Guide

Replacing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
3-11
Verify That the ATM3SA ADAPTER Object Is in the
STOPPED State
3. Select Abort.
4. Click Perform action.
Verify That the ATM3SA ADAPTER Object Is in the STOPPED
State
To verify that the ATM adpater is in the stopped state you can use SCF, the OSM
Service Connection, or the TSM Service Application.
Using SCF
1. Issue this SCF STATUS ADAPTER command:
STATUS ADAPTER $adapter-name
2. Confirm that the output of the command shows the state as STOPPED.
Using the OSM Service Connection or the TSM Service
Application
1. Right-click the ATM adapter and select Attributes from the menu.
2. In the OSM Service Connection, confirm that the value of Device State is
STOPPED.
In the TSM Service Application confirm that the value of SCF State is
STOPPED.
Label the Communications Cables Connected to the ATM3SA
Adapter
To label communications cables for an ATM3SA adapter:
1. Physically locate the group, module, and slot in which the ATM ServerNet adapter
(ATM3SA) is installed.
Figure 3-2 shows the ATM3SA adapter slot locations.