ATM Adapter Installation and Support Guide

Replacing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
3-15
Remove the ATM3SA Adapter
Remove the ATM3SA Adapter
To Remove an ATM3SA adapter:
1. Disconnect the fiber optic cables from the ATM3SA adapter.
2. Put on your electrostatic discharge (ESD) wriststrap and connect the grounding clip
securely to an exposed, unpainted, metal surface on the service side of the system
Figure 3-3. ESD Protected Environment
System Enclosure (Appearance Side)
ESD wriststrap clipped to
door latch stud (or to any
exposed, unpainted, metal
surface on the enclosure
frame.)
ESD wriststrap
with clip
ESD floor mats
ESD antistatic table mat.
Mat should be connected to a soft ground
(1 megohm min. to 10 megohm max.)
Clip 15 inch straight
ground cord to screw
on grounded outlet
cover.
VST693.vsd