ATM Adapter Installation and Support Guide

Replacing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
3-19
Unpack and Install the Replacement ATM3SA
Adapter
the ATM3SA adapter so that its ejector is at the top, as shown in Figure 3-6, and
insert the ATM3SA adapter into the upper part of the carrier.
2. Push the ATM3SA adapter to the rear of the slot, but don't force it.
Figure 3-7 shows how to install an ATM3SA adapter.
Figure 3-6. Ejector in Full-Open Position
Caution. Apply equal pressure to both the top and bottom of the ATM3SA adapter when
pushing it into the slot to avoid damaging the connector pins. If pins are damaged, both the
ATM3SA adapter and the backplane (or enclosure) must be replaced.
VST500.vsd