ATM Adapter Installation and Support Guide

Replacing an ATM3SA Adapter
ATM Adapter Installation and Support Guide—420013-002
3-25
Resume Customer Applications
For a single line, use the SCF STATUS LINE command:
STATUS LINE $line-name
Example 3-15 shows the output of these commands.
Note that the line is in the STARTED state.
For an Expand multiline path, use the SCF STATUS PATH command:
STATUS PATH $path-name
Example 3-16 shows the output of these commands.
Note that the path is in the STARTED state.
Resume Customer Applications
To resume customer applications:
1. Perform any actions necessary to resume customer applications.
2. Notify end users that applications are now available.
Troubleshooting: If an Object is Not in the STARTED State
If a SUBNET, DEVICE, LINE, or PATH object is not in the STARTED state, see
Troubleshooting: If an Object Is Not in the STARTED State on page 2-15.
Example 3-15. SCF STATUS LINE Command
->STATUS LINE $LINE1
EXPAND Status LINE1
Name State PPID BPID CIU-Path ConMgr-LDEV
SATHO0 STARTED 2, 10 3, 7 A 91
Example 3-16. SCF STATUS PATH Command
->STATUS PATH $PATH
EXPAND Status PATH
Name State PPID BPID Lines #
$PSHOT STARTED 2, 15 3, 15 2
Note. The actions required to perform this step depend on the customer's application.