ATM Configuration and Management Manual

SCF Commands
ATM Configuration and Management Manual—522307-003
4-51
INFO ATMSAP Command
INFO ATMSAP Display
The display for the INFO ATMSAP command is as follows:
The definitions of the fields in the INFO ATMSAP displays is as follows:
AAL Mode
specifies the ATM Adaptation Layer (AAL) Mode.
AAL Stype
specifies the AAL.
AAL fwd sdu size
specifies the forward maximum service data unit (SDU) size. This field specifies
the size sent in the direction from the calling user to the called user.
AAL bwd sdu size
specifies the backward maximum SDU size. This field specifies the size sent in the
direction from the called user to the calling user.
High Layer
currently not used.
Low Layer
currently not used.
-> INFO ATMSAP $AM1.#IP
ATM Info ATMSAP \HANSOLO.$AM1.#IP
Call Type
AAL Mode................ MESSAGE AAL Stype................... NULL
AAL fwd sdu size........ 9188 AAL bwd sdu size............ 9188
High Layer.............. 0 Low Layer................... 0
QOS forward............. CLASS0 QOS Backward................
CLASS0
Bearer Class............ CLASS-X Bearer susceptibility....... NO
Bearer Config........... Point-to-Point
MESSAGE Message mode.
STREAM Streaming mode.
NULL Null.
ASSURED Data SSCS based on SSCOP (assured operation).
UNASSURED Data SSCS based on SSCOP (non-assured operation).
FRAME RELAY Frame relay SSCS.