ATM Configuration and Management Manual

SCF Commands

ATM Configuration and Management Manual—522307-003

4-84

STATUS ATMSAP Command

The STATUS ATMSAP command displays the dynamic state of the ATM service

access point (ATMSAP). The state of an ATMSAP object can be either STARTED or

STOPPED.

This is a nonsensitive command.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

ATMSAP atmsap-name

specifies the name of the ATMSAP for which status is to be returned.

SUB { ALL | NONE | ONLY }

selects the subordinate objects the command affects.

ALL

specifies that the named object and the subordinate objects are affected.

NONE

specifies that the name object is affected but that the subordinate objects are

not.

ONLY

specifies that only the subordinate objects are affected.

Default: None.

STATUS ATMSAP Display

The format of the display for the STATUS ATMSAP command is:

STATUS [/OUT file-spec/ ] ATMSAP atmsap-name

[ SUB { ALL | NONE | ONLY }]

-> STATUS ATMSAP $AM1.#IP

ATM Status ATMSAP \HANSOLO.$AM1.#IP

Name State Active PVCs Active SVCs

$AM1.#IP STARTED 0 0