ATM Configuration and Management Manual

SCF Commands
ATM Configuration and Management Manual—522307-003
4-87
STATUS PROCESS Command
Active SVCs
specifies the number of active SVCs.
Time Last Down
specifies the time the ATM line was last down or in the stopped state.
Example
This example shows the STATUS LINE command:
-> STATUS LINE $AM1, DETAIL
STATUS PROCESS Command
The STATUS PROCESS command displays the dynamic state of AMP. The state of a
PROCESS object can be either STARTED or STOPPED.
This is a nonsensitive command.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
PROCESS process-name
specifies the name of the PROCESS for which status is to be returned.
DETAIL
causes the STATUS command to display a list of detailed information about the
specified process object. Without this parameter, the command displays only a
subset of the STATUS PROCESS display.
STATUS PROCESS Display
The format of the display for the STATUS PROCESS command is:
STATUS [/OUT file-spec/ ] PROCESS process-name [ , DETAIL ]
-> STATUS PROCESS $ZAM11
ATM Status PROCESS
Name State PID Pri Trace SvrNetStatus
$ZAM11 STARTED 1, 21 180 OFF ACCESSIBLE