ATM Configuration and Management Manual

SCF Commands
ATM Configuration and Management Manual—522307-003
4-100
TRACE ADAPTER Command
TO file-spec
specifies the file to which trace information is to be written. The file might have
been previously created as an unstructured file with file code 830. An old file is
purged of data before the trace is initiated. If the file does not exist, a file is created
with an extent size based upon the number of PAGES specified.
WRAP
specifies that when the trace disk file end-of-file mark is reached, trace data wraps
around to the beginning of the file and overwrites any data there.
Considerations
•
If TO file-spec is specified, a new trace is initiated unless the file-spec is
invalid, the file cannot be opened, or trace is already active for the IOP.
•
If TO file-spec and STOP are both omitted, the TRACE command modifies the
trace currently in progress, if any.
•
If TO file-spec is omitted and STOP is specified, the TRACE command stops the
trace currently in progress, if any.
Table 4-4. select-spec for an ADAPTER Object
Keyword Number Meaning
ALL
-1 Trace all items
KERNAL
1 Not Used - reserved
HIF
2 Not Used - reserved
DSM
3 Not Used - reserved
DIAG
4 Not Used - reserved
HDRV
5 Not Used - reserved
ADRV
6 Not Used - reserved
ATMDI
7 Not Used - reserved
ATMDO
8 Not Used - reserved
HIFDI
9 Trace all Host Interface Data in events
HIFDO
10 Trace all Host Interface Data out events
LECONFG
11 Not Used - reserved
LESIG
12 Not Used - reserved
LECTRL
13 Not Used - reserved
LEDATA
14 Not Used - reserved
LINE
15 Trace all line tasks
SIG
16 Trace adapter signaling manager tasks