ATM Configuration and Management Manual

ATM Configuration and Management Manual—522307-003
1-1
1 Configuration Quick Start
This section is a configuration quick start for the ATM subsystem. This procedure
explains how to set up the initial ATM processes, objects, and adapters on a
NonStop S-series server.
To help you complete the configuration tasks quickly, this section recommends you
accept the default values provided by the ATM subsystem. If you want to change your
ATM configuration, or if you want to complete the initial configuration without using the
default configuration values, refer to the appropriate sections of this manual.
Task Summary
Task 1: Logging On to the NonStop S-Series Server
Task 2: Creating the ASM Process
Task 3: Adding an Adapter
Task 4: Configuring the ATM Address
Task 5: Starting the ATM LINE
Task 6: Starting the ATMSAP Object
Task 7: Adding the Permanent Virtual Circuit (PVC) Object
Assumptions
At the beginning of the procedure, the NonStop S-series server is in the following state:
•
The default software configuration is as shipped by manufacturing.
•
The initial TSM or OSM configuration is complete.
•
A third-party ATM switch has been installed and configured. The port used on the
ATM switch to connect to the ATM adapter must be enabled by the Interim Local
Management Interface (ILMI). If you do not use the ILMI feature, you must also
make a note of the ATM address for manual registration. For more information, see
Task 4: Configuring the ATM Address on page 1-3.
•
The ServerNet LAN Systems Access (SLSA) subsystem has been defined and
started with the generic configuration provided from manufacturing, and Ethernet
4-port ServerNet adapters (E4SAs) have been installed and started.
•
The QIO subsystem is started.