ATM Configuration and Management Manual

Configuration Quick Start
ATM Configuration and Management Manual—522307-003
1-3
Task 3: Adding an Adapter
Task 2 is required only when you configure the ATM subsystem for the first time.
Task 3: Adding an Adapter
To add an adapter to the ATM subsystem:
1. Fill out a configuration form for the adapter as described in Section 3, Configuring
the ATM Subsystem.
2. Install the adapter in the system. For more information on how to install an
ATM3SA ServerNet adapter, see the ATM Adapter Installation and Support Guide.
3. Use the SCF ADD ADAPTER command to add the adapter to the ATM subsystem.
There is a 3-character limit on the name of the adapter.
4. Use the SCF START ADAPTER command to start the adapter.
Task 4: Configuring the ATM Address
This task is optional. If you allow the ILMI feature to automatically create the address,
you do not need to manually set the address yourself.
If you do not want to use the ILMI feature, you must configure the ATM address for
each ATM adapter you are running on a NonStop S-series server. The ATM address is
the one previously used when installing and configuring the third-party ATM switch.
To configure the ATM address, use the SCF ALTER LINE command.
Task 5: Starting the ATM LINE
Once you have configured the ATM address, you must start the LINE using the SCF
START LINE command.
Use the SCF START LINE command to start the LINE object.
->ADD ADAPTER $ZZATM.$AM1, LOCATION (1,1,53), ACCESSLIST (0,1)
->START ADAPTER $AM1
-> ALTER LINE $AM1,ATMADDR
(isonsap:%h4700dd01272b4a00000000000000000000000100)
->START LINE $AM1