ATM Configuration and Management Manual

Configuring the ATM Subsystem
ATM Configuration and Management Manual—522307-003
3-5
Configuration Quick Start
Configuration Quick Start
To configure ATM ServerNet connections:
Step 1: Create and Start the ASM Process
Before you can start the ATM subsystem process, you must create and start one ASM
process on each NonStop S-series server where you are connecting an ATM adapter.
Use the SCF ADD PROCESS and START PROCESS commands.
ADD PROCESS Command
Create the ASM process as a generic process. Use the Kernel subsystem SCF ADD
PROCESS command:
Task Tool Used
Step 1: Create and Start the ASM Process
on
page 3-5.
SCF interface to the Kernel subsystem
Step 2: Create and Start the ATM Adapter
on
page 3-10.
SCF interface to the ATM subsystem
Step 3: Configure the ATM Address and Start
the Line on page 3-14.
SCF interface to the ATM subsystem
Step 4: Start the ATMSAP Object
on page 3-18 SCF interface to the ATM subsystem
Step 5: Create and Start the PVC Object
on
page 3-18
SCF interface to the ATM subsystem
Note. The SCF syntax in this subsection which you use to configure ATM ServerNet
connections is not the complete syntax for the described SCF commands. For more
information about the SCF command syntax for other subsystems, see the appropriate SCF
reference manual
.
Note. Step 1 is required only when you configure the ATM subsystem for the first time.
ADD PROCESS $ZZKRN.#gpname
, AUTORESTART n
, BACKUPCPU n
, DEFAULTVOL $vol [.subvol ]
, HOMETERM $device [.#subdevice]
, INFILE {$device | [[$vol.]subvol.]filename }
, NAME $name
, OUTFILE {$device | [[$vol.]subvol.]filename
, PRIMARYCPU n
, PRIORITY n
, PROGRAM [[$vol.]subvol.]filename
, SAVEABEND { ON | OFF }
, STARTMODE { KERNEL|SYSTEM|APPLICATION|MANUAL|DISABLED }
, STARTUPMSG "text"
, TYPE { SUBSYSTEM-MANAGER|OTHER }