ATM Configuration and Management Manual

Configuring the ATM Subsystem
ATM Configuration and Management Manual—522307-003
3-13
Example
SYSNAME string
specifies the system name. The string specified must be in the range 0 through
256. This attribute is for informational purposes only.
Default: blanks.
SYSOBJID string
specifies the vendor’s authoritative ID of the Network Management subsystem
contained in the entity. The string specified must be in the range 0 through 256.
This attribute is for informational purposes only.
Default: blanks.
SYSSERVICE digit 1-7
specifies the services offered for this entity. This attribute is for informational
purposes only.
The values are defined as:
1 - Physical (for example, repeaters)
2 - Datalink/Subnetwork (for example, bridges)
3 - Internet (for example, IP routers)
4 - End-to-end (for example, IP hosts)
5 - Undefined
6 - Defined
7 - Applications (for example, mail relays)
Default: 4.
DFC digit 1-50
specifies how many packets the adapter will receive before sending them to the
host. If the Data Forwarding Count (DFC) is set to 1, packets are forwarded
immediately, and Data Forward Timer (DFT) is disabled. The default is 2.
DFT (1-200)/1000th seconds
specifies how many milliseconds the adapter will wait before packets are sent to
the host. The default is 1.
Example
The following command creates an adapter named $AM1:
-> ADD ADAPTER $ZZATM.$AM1, LOCATION (1,1,53), ACCESSLIST
(1,2)