ATM Configuration and Management Manual

SCF Commands
ATM Configuration and Management Manual—522307-003
4-34
ALTER ADAPTER Command
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ADAPTER adapter-name
specifies the name to be assigned to the ADAPTER.
DLFILENAME filename
specifies the name of the download file to set up the ADAPTER.
Default: $SYSTEM.SYS*.C7838P00. The SYS* indicates the SYSnn of the current
running system.
FIRMWFILENAME filename
specifies the adapter firmware file name. The firmware file name contains the
firmware or boot code for the adapter.
Default: $SYSTEM.SYS*.C8158R00. SYS* indicates the SYSnn of the current
running system.
DUMPFILENAME filename
specifies the dump file to be used for AMP.
The default value is $SYSTEM.SYS*.C7838D00. SYS* indicates the SYSnn of the
current running system.
ALTER [/OUT file-spec/] ADAPTER adapter-name
[ , DLFILENAME filename ]
[ , FIRMWFILENAME filename ]
[ , DUMPFILENAME filename ]
[ , AUTODUMP { ON | OFF } ]
[ , AUTOFIRMUP { ON | OFF } ]
[ , AUTORELOAD { ON | OFF } ]
[ , PROBEINTERVAL 1/100 seconds ]
[ , PROBECOUNT digit ]
[ , SYSCONTACT string ]
[ , SYSDESC string ]
[ , SYSLOCATION string ]
[ , SYSNAME string ]
[ , SYSOBJID string ]
[ , SYSSERVICE digit 1-7 ]
[ , DFC digit 1-50 ]
[ , DFT (1-200)/1000th seconds ]