AutoSYNC Software User's Guide (Update 14)

Command Interpreter
HP AutoSYNC User’s Guide—522580-015
8-47
ALTER SYNCFILESET
By default this option is enabled and file security is changed as follows:
The default is NETWORKSECURE, but the SECURE option overrides
NETWORKSECURE.
NOSAFEGUARD | NO NOSAFEGUARD
specifies that the Safeguard ACL for a source Enscribe disk file is not
propagated to the destination when the file is synchronized. A warning is
written to the logfile to notify the user that the Safeguard setting for the source
file has been turned off on the destination.
The default is NO NOSAFEGUARD and the ACL for a source file is
propagated to the synchronized destination file.
RECOVER[Y] | NO RECOVER[Y]
enables or disables the recovery option.
If recovery is enabled, AutoSYNC saves a copy of an existing destination file to
an archive subvolume before it restores a later copy of the file. If a failure
occurs during the synchronization and the file is corrupted, the archived copy is
recovered and replaces the corrupted file.
This option overrides the global parameter [AUTO]SYNCRECOVER.
By default, recovery is enabled.
RENAMEO[PEN] | NO RENAMEO[PEN]
specifies (or disables the option) that remote unaudited files that are opened
for shared READ access or running object files are to be renamed to allow
AutoSYNC to replace them.
The syncuser must have PURGE privileges to the remote file for the RENAME
to succeed.
Both the old and new file names are recorded in an AutoSYNC index file called
AAINDEX, located in the MapDB subvolume.
The renamed files are named AAnnnnnn, where nnnnnn is a sequence
number, and are placed in same subvolume name as the AutoSYNC MapDB,
Source file security Destination file security
“A” “N”
“G” “C”
“O” “U”
“-” “-”