AutoSYNC Software User's Guide (Update 20)

Command Interpreter
HP AutoSYNC User’s Guide—522580-021
8-25
ADD SYNCUSER
the group ID of the destination file set.
If OWNERGROUP is omitted, the group ID is one of:

the group ID specified in the OWNER option, if it is entered

the group ID of the source file otherwise.
SECURE “rwxrwxrwx”
the security of the destination file set.
"rwxrwxrwx" settings are for user, group and others.
The accepted values are:

"r" grants read access

"w" grants write access

"x" grants execute access

"-" denies access for read, write and execute setting.
If this option is omitted, the security of the destination file set is the same as
that of the source file set.
The exception is write security for the owner: when a file or a directory is
synchronized and the write access was denied for the owner in the source file,
write access is granted in the destination file to allow subsequent
synchronizations. Write access is only upgraded when the syncuser is the
owner of the file and not SUPER.SUPER. When the super ID is used, the
owner write security setting is not upgraded.
ADD SYNCUSER
Authorizes a specific user (ggguuu) to schedule synchronizations. The command
automatically creates a schedule table (SFggguuu) and synchronization log file
(SLggguuu) in the MapDB subvolume.
The SFggguuu table contains the user’s syncfileset definitions and it is secured to
allow updates only by user ggguuu. Each syncuser can configure up to 32767
syncfilesets.
The log file SLggguuu is an Enscribe entry-sequenced file where AutoSYNC stores the
outcome of the scheduled synchronizations performed on behalf of the syncuser.