AutoTMF Software User's Guide (Update 11)

Installation and Basic Management
HP NonStop AutoTMF Software User’s Guide—429952-013
2-8
Update System Coldload Procedures
When the monitor process is started, the following messages should be displayed by
the EMS distributor:
The monitor process is a fault-tolerant process-pair that has the process name $ZESC;
you should not have to restart it unless you intentionally stop it or cold load the system.
If you discover that the monitor process is not running, start it by using the command:
You may wish to configure the NonStop AutoTMF monitor process parameters, such
as priority and cpus. In particular, the monitor priority should be higher than all
application programs to avoid delays during process startup.
The section Monitor Process
on page A-2 describes, in detail, how to configure and
determine the status of the Monitor process.
Update System Coldload Procedures
Once you alter the database files to be audited, the NonStop AutoTMF monitor process
becomes a critical component of application availability. You must ensure that the
monitor process is started whenever system maintenance has required it to be
stopped. You should include the start of the monitor process with the other operational
steps that normally follow a system cold load.
16:33 08MAY07 099,01,130 AutoTMF Monitor $ZESC Starting Version
1.8.1 - 23APR2007
16:33 08MAY07 099,01,130 AutoTMF Monitor $ZESC Message
AutoTMF License Information
Valid from date: None
Expiration date: Oct 15 2007
Maximum logical processors 8
16:33 08MAY07 099,01,130 AutoTMF Monitor $ZESC Message
AutoTMF Global Settings
AutoTMF ON
ATMFCommonTx ON
ATMFMaxTime 16 (seconds)
ATMFMaxUpdate 32
ATMFNowait OFF
ATMFIsolation Weak
ATMFTxHoldoff 0 (seconds)
ATMFAuditRename ON
ATMFSkipNullRecs ON
ATMFReadThruLock ON
ATMFAutoCommit OFF
ATMFAbendNoAudit OFF
ATMFOptmzUnlocks OFF
ATMFSTOPonTMFErr ON
ATMFMaxTX 100
DynamicTrace ON
SecureTrace ON
EMSCollector $0
16:33 08MAY07 099,01,130 AutoTMF Monitor $ZESC Started
16:33 08MAY07 099,01,130 AutoTMF Monitor $ZESC ATMFFILE table cached.
Table entry count = 1.
16:33 08MAY07 099,01,130 AutoTMF Monitor $ZESC ATMFPROG table cached.
Table entry count = 2.
16:33 08MAY07 099,01,130 AutoTMF Monitor $ZESC Backup started, cpu 0
START MONITOR;