AutoTMF Software User's Guide (Update 12)

NonStop AutoTMF Software Commands
HP NonStop AutoTMF Software User’s Guide—429952-014
6-70
MODIFY MAPDBS
MODIFY MAPDBS
Copies all entries of MAPDBS that were defined for the system called nodename and
creates the same entries for the local system. If the MAPDBS entry is already defined
on the local system, the MAPDBS entry is not copied from the original system.
The command does not:
•
copy the actual MAPDB tables
•
verify that those tables are present on the local system
•
make any changes that may be required to migrate the content of MAPDB tables
to the local system.
nodename
the Expand node name of the original system.
LISTALL
displays the entries that are being modified in the MAPDBS table.
MONITOR
The MONITOR command sends a command to the monitor process. Refer to Monitor
Commands on page 6-91 for a list of valid monitor commands
[\sys.]process-name
specifies an executing monitor process. If omitted, the monitor for the current
MapDB will be used.
*
specifies all executing monitor processes.
command-text
is all text up to the end of the current command line. A MONITOR command
cannot be continued on multiple lines. A semi-colon is neither required nor
recognized as a command terminator.
MODIFY MAPDBS REPLACE NODENAME nodename [ , LISTALL ];
Note. The command assists you in migrating the configured Monitor and MapDB attributes to
a new system.
For details on migration procedures, see “Migrating the NonStop AutoTMF
Software Configuration to a New System” on page A-7.
MONITOR [ [\sys.]process-name | * ] command-text