5 Access Server Configuration and Management Manual

Configuring User and Port Access

AWAN 3883/4/5 Access Server Configuration and Management Manual—424242-001

7-14

Configuring Port Access

To configure port access, you must perform the following steps:

1. Enable the appropriate protocols for each port.

2. Configure security for each port.

3. Reset the port.

Step 1: Enabling Protocols for a Port

To enable a protocol for a specific port, choose Properties... from the Port-Specific

menu. The Port Properties screen is displayed with the Modem tab active. Click on the

Protocols tab to display the Protocols tab dialog box. The Protocols tab dialog box is

shown in Figure 7-8.

Note. Port protocol settings have priority over user protocol settings. For example, if PPP is

disabled on a port, no user—not even one who is enabled for PPP—can dial into that port

using PPP.

Figure 7-8. Port Properties Screen—Protocols Tab Dialog Box