5 Access Server Configuration and Management Manual

Configuring User and Port Access

AWAN 3883/4/5 Access Server Configuration and Management Manual—424242-001

7-15

Step 2: Configuring Security Protocols for a Port

To configure port security, click the Security tab. The Security tab dialog box is

displayed as shown in Figure 7-9.

Step Action Comments

1. Enable the check boxes for the

protocols you want to enable for this

port.

Refer to the protocols recorded for this port

on your Port Configuration Worksheet.

For information about how to select

protocols for ports, refer to Determining IP

Address Assignments for Users on page 7-3.

2. Click Apply.

Note. For IPX-over-PPP and NRN connections only: The remote-node address is

configured by selecting Properties... from the Server Characteristics and Properties menu and

then clicking on the IPX tab. The remote-node address is assigned to users and is shared

across all ports. Refer to Configuring IPX Properties

on page 6-6 for more information.

Figure 7-9. Port Properties Screen—Security Tab Dialog Box