AWAN 3883/4/5 Access Server Configuration and Management Manual

Configuring the 6530 Gateway Feature
AWAN 3883/4/5 Access Server Configuration and Management Manual—424242-001
10-8
Function-Key Mapping
Table 10-4. VT Option Signal Window Commands (page 1 of 2)
Signal Command Function Description
Default Single
Key
none Close or open signal window Control L
REF Refreshes the entire display Control R
DIS Disconnect the terminal session Control Z
L25 Toggle line 25 display Control O
BR Break key Control B
UNL Unlock keyboard Control U
IC Insert Char no default
DC Delete Char no default
IM Toggle Insert Mode no default
KEYSIG Redefine Signal key
KEYDIS Redefine DIS key
KEYL25 Redefine L25 key
KEYBR Redefine BR key
KEYUNL Redefine UNL key
KEYIC Redefine IC key
KEYDC Redefine DC key
KEYIM Redefine IM key
L25TO n Controls the automatic display of line 25
(Escape o or hex 1b 6f) updates from the host
application. The line 25 text is displayed on line
24 of the VT-series terminal, temporarily
replacing the normal data on that line. Regardless
of the setting of L25TO, the terminal user can
always use Control O to toggle the line 25 display
on and off. The L25TO command specifies a
single numeric value in the following format:
•
n = 0 (automatic display of line 25 is
disabled; this is the default value at session
startup)
•
n = 1-254 (line 25 is automatically displayed
for n seconds and then turned off)
•
n = 255 (line 25 is automatically displayed
and remains until Control O is used)
BT Back Tab
CU Cursor Up
CD Cursor Down