AWAN 3883/4/5 Access Server Configuration and Management Manual

Configuring Dial-Out Connections
AWAN 3883/4/5 Access Server Configuration and Management Manual—424242-001
11-7
Configuring NASI Dial-Out Connections
Configuring NASI Dial-Out Connections
NASI dial-out enables a PC connected to the local Novell NetWare network to connect
to an internal or external modem attached to the AWAN access server. Configuring
NASI dial-out involves a number of tasks. Table 11-2
describes each task in the order in
which it should be performed.
Finally, you should save and store your configuration changes as described in Saving a
Configuration File on page 5-27 and Storing a Configuration File on page 5-29.
Configuring a NASI Dial-Out Port on the AWAN Access Server
To configure a NASI dial-out port on an AWAN access server, you must perform the
following steps:
1. Configure line and modem properties for the modem port module port or
asynchronous port where the external modem is connected.
2. Configure advanced line properties for the modem port module port or
asynchronous port where the external modem is connected.
3. Reset the port.
Table 11-2. NASI Dial-Out Connection Configuration Tasks
Task Description Purpose
1. Configuring a NASI Dial-Out
Port on the AWAN Access Server
To configure a dial-out port on the AWAN
access server.
2. Configuring NASI Dial-Out
Users on the AWAN Access
Server
To configure the users who will be able to dial
into the AWAN access server using NASI.
3. Configuring Workstations for
NASI Dial-Out
To configure the software needed on a
workstation to dial out of the AWAN access
server using NASI.
Note. Accessing the menus used to perform the configuration tasks described in this
subsection is described in Section 5, Using the RAS Management Tool
.
Note. All AWAN access server ports can be shared between dial-in and dial-out applications.