AWAN 3883/4/5 Access Server Configuration and Management Manual

Command Line Interface (CLI) Commands
AWAN 3883/4/5 Access Server Configuration and Management Manual—424242-001
C-20
Common CLI Commands
Common CLI Commands
This subsection provides command syntax for commonly used CLI commands.
Server Information Commands
The following commands display information about an AWAN access server.
Show Server Command
Use this command to display the following:
•
firmware version
•
AWAN access server name, model number, installed RAM, port module, and link
module information
•
Media access control (MAC) address
Show Server Status Command
Use this command to display the number of active (login in) ports, the number of
connected sessions, and the following:
•
Buffer pool size and usage
•
Information about any connected GAP processes
•
Totals for all ports displayed for the information described under Show Port Count
IP Address Commands
Show Internet Command
Use this command to display the IP address and subnet mask for the AWAN access
server:
Note. Additional commands are described in Starting a Telnet Session on page C-13 and
Diagnosing Problems on page C-14.
Show Server
Show Server Status
Note. IP address commands correspond to information on the IP index tab in the RAS
Management Tool. For more information about the IP index tab, refer to Configuring IP
Properties on page 6-5.
Show Internet