5 Access Server Configuration and Management Manual

Command Line Interface (CLI) Commands

AWAN 3883/4/5 Access Server Configuration and Management Manual—424242-001

C-22

Telnet Listener Commands

Change Telnet Listener Connections Command

Use this command to enable or disable a Telnet service for specified TCP port:

tcp-port

is a TCP port number in the range 2001 to 2064.

Enabled | Disabled

is used to enable (Enabled) or disable (Disabled) the Telnet service.

Change Telnet Listener Port Command

Use this command to associate a TCP port with one or more asynchronous ports on the

AWAN access server:

tcp-port

is a TCP port number in the range 2001 to 2064.

port-list

specifies the physical port or ports on the AWAN access server that you want to map

to the TCP port number. You can specify a single port number or multiple port

numbers separated by commas.

Clear Telnet Listener Command

Use this command to disassociate a TCP port number from a physical port on the

AWAN access server:

tcp-port

is a TCP port number in the range 2001 to 2064.

Note. Telnet listener commands correspond to the information on the Telnet dialog box. For

more information about the Telnet dialog box, refer to Setting Up a Telnet Service

page 11-4.

Change Telnet Listener tcp-port Connections [Enabled |

Disabed]

Change Telnet Listener tcp-port Port port-list

Clear Telnet Listener tcp-port