AWAN 3883/4/5 Access Server Configuration and Management Manual

Command Line Interface (CLI) Commands
AWAN 3883/4/5 Access Server Configuration and Management Manual—424242-001
C-29
Port L0 Commands
•
The following Show Port fields apply to the 6530 protocol:
•
Port
•
Server
•
Character Size
•
Flow Control
•
Parity
•
Input Speed (output speed is always the same as input speed)
•
Signal Control
•
Access
•
Type
•
Preferred Service
Of the Enabled Characteristics, only Autoconnect is of interest.
List Port Command
Use this command to display permanent configuration settings for a specified port.
port-list
specifies the physical port or ports on the AWAN access server that for which you
want to display configuration settings. If this parameter is omitted, the settings for
the current port are displayed.
Most of the command considerations describe for the Show Port command in Show Port
Command on page C-28 also apply to the List Port command.
Port L0 Commands
Use the port L0 commands to configure port L0 on the AWAN access server. Port L0 is
the template port for the 6530 gateway feature. You configure port L0 with Tandem
NonStop Server information so that users will be connected to the Tandem NonStop
server when they use Telnet to connect to the AWAN access server.
Note. The List Port command displays information that is shown on the Line and Adv. Line tab
dialog boxes.
List Port [ port-list ]
Note. The port L0 commands correspond to the information on the Port L0 Configuration
dialog box. For more information about the Port L0 Configuration dialog box, refer to
Configuring Port L0 on the AWAN Access Server
on page 10-3.