5 Access Server Configuration and Management Manual

Installing the Software

AWAN 3883/4/5 Access Server Configuration and Management Manual—424242-001

3-2

Software Utilities Floppy Disks

The Software Utilities floppy disks contain two applications:

•

Com Port to NASI Redirector for Windows

•

INT14 to NASI Redirector for DOS

The Com Port to NASI Redirector for Windows application enables a PC connected to a

Novell NetWare network to redirect a serial communications port to a Network

Asynchronous Services Interface (NASI) service. The INT14 to NASI Redirector for

DOS application enables a PC connected to a Novell NetWare network to support NASI.

The Redirector applications are required on PCs used to dial-out from the AWAN access

server to a Novell NetWare network.

For more information about the Redirector applications, refer to Software for Novell

NetWare Networks on page 9-11.

Installing the Management Software

To install the Management software, perform the following steps:

1. Insert the Management floppy disk numbered 1 into your floppy drive (usually

called A or B).

2. Start the installation program:

•

Windows 3.11 or Windows NT 3.51: Start Windows and choose Run from the

File menu in the Program Manager. Type a:\setup (or b:\setup) and then

press the Enter key.

•

Windows 95 or Windows NT 4.0: Start Windows and then start Explorer.

Double-click on the drive where you inserted the floppy disk; finally, double-

click on Setup.exe.

3. Follow the on-screen instructions to install the Management software. A message

appears when the installation is complete.

For Windows 3.11 and Windows NT 3.51, the installation program creates a program

group called RAS Management in the Program Manager. For Windows 95 and Windows

NT 4.0, the installation program creates a new item in the Start button menu called RAS

Management.

Note. Exit any running applications before you begin the following installation procedure.