AWAN 3886 Server Installation and Configuration Guide

Introduction to AWAN 3886-Series Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
1-8
AWAN 3886-32 Server (DECserver 732) 32
Asynchronous Ports
Figure 1-3. Front Panel of the AWAN 3886-32 (DECserver 732)
1.
System reset switch. To restore factory settings, press and hold this switch during
power-up until the green OK LED starts flashing. This reloads the factory set
parameters and all customized parameters are lost.
2.
System OK LED. Lights when the AWAN server has power.
3.
Flash card slot. Provides an opening in which to insert the Flash RAM card.
4.
EIA-232 asynchronous serial ports. These 16 asynchronous 8-pin MJ ports connect
devices to the AWAN server.
5.
Seven-segment Display. Provides error and status information:
Blinks: If an error occurs during self-test
Off: The AWAN server failed self-test
Rotating Figure ‘8’: Operating image loaded and running
See Seven-Segment LED Display and Codes
on page 3-6.
6.
Ethernet address (MAC address label). Used for the Ethernet address label. This is
where the MAC address label resides.
7.
10BaseT and AUI selector switch. Enables you to select between the Ethernet
10BaseT and AUI port on the server.
Up: 10BaseT is selected
Down: AUI port is selected
8.
10BaseT port connector. This single female RJ45 connector connects to a 10BaseT
Ethernet/IEEE 802.3 local area network through an RJ45 connector.
9.
AUI selection LED.
On: AUI port is selected
Off: No AUI port is selected
DECserver 732
#
#
LNK
8
1357 1510 12 14
24 68 1691113
17
18
19
20
21
22
23
24
25
26 32
27
28 30
3129
1 2
3
4
5
6
7
8 9
10
11
12
vst32.vsd