AWAN 3886 Server Installation and Configuration Guide

Introduction to AWAN 3886-Series Servers

AWAN 3886 Server Installation and Configuration Guide—427428-006

1-9

AWAN 3886-32 Server (DECserver 900) 32

Asynchronous Ports

Back Panel of AWAN 3886-8A, 3886-16, and 3886-32 Servers

Note that on the DECservers 716 and 732, the power receptacle is on the back panel

of the unit and on the opposite side of the Ethernet connectors and EIA ports.

AWAN 3886-32 Server (DECserver 900) 32 Asynchronous Ports

The AWAN 3886-32 server (DECserver 900) operates as a stand-alone module with

the DEChub ONE product. Support for the 32-port 3886 AWAN model is the same as

for the Earlier AWAN 3886 Servers on page C-1, with the exception of:

•

Thirty-two asynchronous RS-232 ports with RJ45 connectors. (Adapter connectors

are available. See Appendix A, Adapters for Cables and Devices.)

•

External Flash RAM.

•

Supports the 16-port RS232 to 20MA Current Loop Converter

10.

10BaseT selection LED

On: 10BaseT port is selected

Off: No 10BaseT port is selected

11.

LNK LED

On: Ethernet connection to a 10BaseT connection or the AUI port is selected

Off: No Ethernet connection to a 10BaseT connection and no AUI port selected

12.

AUI port. Ethernet connection through an AUI port connection.

Figure 1-4. Back Panel of AWAN 3886-8A, 3886-16, and 3886-32 Servers

1. Fan. Expels hot air from inside the AWAN server.

2. Power Receptacle. The AWAN server power cord plugs into this receptacle.

Note. Due to end-of-life components in this server, it is being replaced by the AWAN 3886-32

Server (DECserver 732) 32 Asynchronous Ports. For information on the differences between

older servers and replacement servers, refer to AWAN Replacement Servers for DECserver

700 (16 port) and DECserver 900 (32 port) on page C-4.

AWAN 3886-8A, 3886-16, and 3886.32 Servers - Back Panel

VST401.vst