AWAN 3886 Server Installation and Configuration Guide
Introduction to AWAN 3886-Series Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
1-10
AWAN 3886-32 Server (DECserver 900) 32
Asynchronous Ports
The 3886-32 has only the standard Ethernet AUI connector, and it must connect to the
DEChub ONE or to a DEChub. The 3886-32 AWAN server requires an AUI to
10BaseT transceiver. See Table 1-2, Converters, on page 1-13.
Figure 1-5 shows the front panel of a 3886-32 (DECserver 900TM) model.
Note. The 3886-32 provides only partial modem-signal support. For more information, see the
manuals on the CD ROM.
Figure 1-5. Front Panel of a 3886-32 Model (DECserver 900TM)
1. Power LED. Lights when the server has power.
2. OK LED. Lights when the server passes self-test. Flashes when a non-fatal error
occurs on self-test. If the module fails self-test, the OK LED light is off.
3. Network Traffic
4. Network OK. Lights when the server has an active network connection.
5. Seven-Segment Display. Provides error information. See Seven-Segment LED
Display and Codes on page 3-6.
6. Flash RAM Slot
1
2
3
4
5
6
7
8
9
11
10
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
vst901.vsd
8
12
34
5
6
7
8