AWAN 3886 Server Installation and Configuration Guide

Introduction to AWAN 3886-Series Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
1-11
AWAN 3886-32 Server (DECserver 900) 32
Asynchronous Ports
DEChub ONE
The DEChub ONE supplies an Ethernet-only connectivity through an integral AUI port.
An optional Ethernet MAU can be used in with the DEChub ONE to convert from a
15-pin AUI to ThinWire or 10BaseT. Figure 1-6 on page 1-11, taken from the DEChub
ONE manual, shows the DEChub ONE connected to a network module, such as a
3886-32 AWAN server (DECserver 900TM):
7. Factory Configuration Reset Switch. Used to reset all configuration parameters to
factory default values. Press and hold this switch when applying power to the server
until the OK LED blinks rapidly (about 10 seconds). Release the switch to allow
initialization to proceed.
The Factory Configuration Reset Switch is also active while the server is
running. If this switch is pressed and held (about 10 seconds) while the
server is running, the server will reboot and perform a factory configuration
reset. Be careful not to inadvertently press this button during normal
operation.
8. 32 RS-232 asynchronous ports
Figure 1-6. DEChub ONE with 3886-32 AWAN Model
CDT067.CDD
9
1
2
8
7
3
45 6
RJ45