AWAN 3886 Server Installation and Configuration Guide

Introduction to AWAN 3886-Series Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
1-12
Hardware: AWAN 3886 Models, Printers,
Converters, Adapters
The AUI (15-pin) to 10baseT (RJ45) connector (422781-001) is used to adapt the AUI
port for use with 10BaseT, twisted-pair.
Hardware: AWAN 3886 Models, Printers,
Converters, Adapters
The following tables list the servers, peripherals, and adapters you might need. You
can order these hardware units from HP.
AWAN 3886 Servers (DECServers)
Table 1-1 lists the available AWAN 3886 servers (DECServers).
The part numbers for the AWAN 3886 units are positioned on the back panel of the
unit or the bottom surface. To view a list of part numbers, from the home page of the
NonStop Technical Library (NTL), select Support and Service > Service Information
> Part Numbers.
For information on safety and regulatory operating requirements, see the section on
Safety and Compliance and FCC Regulations at the end of this guide.
1. DEChub ONE
2. AC power connector
3. OBM port Led
4. 9-pin OBM port connector (not used)
5. Setup port connector (not used)
6. AUI port and slide latch
7. AUI (15-pin) to 10baseT (RJ45) (included when the unit is ordered)
8. Locking L-bracket
9. DECserver 900TM full-height network module
Table 1-1. AWAN 3886 Servers (DECservers)
Product Ports Description
DSVR708 8 3886-8A (DECserver 708)
TDSVR716 16 3886-16 (DECserver 716)
SVR900TM 32 3886-32 (DECserver 900TM)
DECHub One N/A For use with the 3886-32
(DECserver 900TM)
Transceiver N/A For use with the 3886-32
(DECserver 900TM)
SRV732 32 3886-32 (DECserver 732)