AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-6
Install the AWAN 3886-16 and 3886-32 (DECserver
716 and 732)
Install the AWAN 3886-16 and 3886-32 (DECserver 716 and 732)
The following steps outline installing the 3886-16 and 3886-32 AWAN models.
1. For hardware installation, follow the product manuals located in the “Doc” folder on
the CD.
2. If you are using the DECserver 716 and DECserver 732, set the Ethernet selector
switch to either 10BaseT (up) or AUI (down). The 10BaseT and standard Ethernet
connections are not self-sensing.
Figure 2-2 on page 2-6 shows the options available with the Ethernet Selector
Switch: 10BaseT has been selected, for the LED light is dimmed for AUI (bottom)
and the 10BaseT Selection LED (middle) is lit. (For purposes of clarity, the
illustration does not show an Ethernet cable connected.)
Note. You must set the Ethernet Selector Switch before you power-on the AWAN unit.
Figure 2-2. Ethernet Selector Switch: DECserver 716 and DECserver 732
VST400.vsd
Ethernet
cable
AUI
10BaseT
Seven-
Segment
Display
10BaseT
LED
LNK
LED
AUI LED
Ethernet Selector Switch
MAC Address
Down
AUI
Up
10BaseT