AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers

AWAN 3886 Server Installation and Configuration Guide—427428-006

2-7

Install the AWAN 3886-32 (DECserver 900TM)

If you are using the AWAN 3886-32 unit (DECserver 900TM), you must install the

DEChub ONE. See the DEChub ONE Manual. You must install the

15-pin transceiver, MAU, if you are using an AUI. The MAU has its own installation

manual that is packaged with the product.

1. For complete instructions about installing the DECserver 900 with the DEChub

ONE, see page 5 in the DEChub ONE Manual. Figure 2-3 shows attaching the

3886-32 AWAN DECserver 900TM unit to the DECHub ONE.

2. As instructed in the manual, and as shown in the illustration, make sure that you:

a. Lift the locking L-bracket screw on the DEChub ONE and pivot the DECserver

900TM into place to engage both the 160-pin and the 48-pin connectors.

b. Tighten the locking L-bracket screw.

3. Use port 1 to transmit boot activity. For all the AWAN units, only port 1 displays

bootup and download activity to a terminal.

Note. Before you attach the DEChub ONE to a 3886-32 AWAN (DEC900TM) unit, make sure

that you first write down the MAC address and place a label indicating the MAC address on the

top or side of the AWAN unit where you can see the label after the unit is joined with the

DEChub ONE. See Figure 2-3, DEChub ONE Installation Showing MAC Address, Mounting

Tab and Locking L-Bracket.